The question was prompted by this person's complaint of being blinded by the lights of many of today's vehicles. These vehicles display two headlights and two of what many people assume to be driving lights.
Driving lights are identified by the markings SAE-Y on North American lamps or the letters HR above the circle containing the "E" on European lamps. You are allowed to install two of them that display only white light. They must be mounted between 40 cm and 1.06 m from the ground level and aimed so that the high intensity portion of the beam is, at a distance of 8 m from the lamp, at least 12 cm below the height of the lamp and, at a distance of 25 m from the lamp, not higher than 1.06 m from the road surface. The lateral aim is +/- 150 mm at a distance of 7.62 m from the lamp.
In addition, these lamps must be wired so that they only come on when the high beam headlights are illuminated. This is usually accomplished through the use of a relay that is triggered when the headlights are switched to high beam. This would mean that a driver would shut off driving lights no closer than 150 m to another vehicle being approached or overtaken.
Driving lamp glare elimination is the ultimate responsibility of the driver of the vehicle using them. Keeping them clean and properly adjusted will solve many complaints and dimming them responsibly will solve most others. Enforcement is the responsibility of the police and the Superintendent of Motor Vehicles as the use of this type of lamp is not regulated by the federal government through Transport Canada.
This article is written by or on behalf of an outsourced columnist and does not necessarily reflect the views of Castanet.